Product Manual

2
Driveway Alarm
Place the SENSOR immediately next to the driveway to
maximize the sensing range, but at least 25 feet from
roadways, neighbor’s driveways or large moving metal
objects.
The 15 ft. cable connecting the SENSOR and
TRANSMITTER allows for the placement of the
TRANSMITTER away from the driveway in the concealment
of landscape or closer to the RECEIVER.
The approximate transmitting range from the
TRANSMITTER to the RECEIVER is 400 ft. Range can
vary depending on environmental conditions such as RF
interference and topography. Some adjustment may be
required.
NOTE: DO NOT place the TRANSMITTER in the
direct path of a sprinkler. The module is water
resistant but not waterproof.
If you don’t use the full 15 ft. of signal cable from
the SENSOR to the TRANSMITTER, coil the extra
cable and bury it beside the transmitter stake.
Installation Overview
Place Driveway Sensor at least
25 feet from roadways, neighbor’s
driveways to prevent false signals
Senses vehicles and
large moving metal objects
within a 12 foot radius
ROADWAY
Up to 400 foot range
from transmitter to receiver
For Optimum Performance:
• LocatetheSENSORasfaraspossibleawayfrompowertransformers,powerlines,
underground gas line, and telephone lines.
• LocatetheSENSORawayfromgeneralmovingtrafctopreventunwantedactivation.
RememberthattheSENSORdetectsMAGNETICDISTURBANCEScausedbyavehicle’s
mass and velocity.
• Rangedistanceisapproximateandwillvaryduetooutsideinterference,typeofsoil,
vehicle mass, speed, etc.
• ItisrecommendedthatyouruntheSignalCableinsidePVCconduittoprevent
accidental damage.
• DonotruntheSignalCableinconduitwithotherwiressuchasACpowerorother
control wires.
•TheSIGNALCABLECANNOTBESPLICED.