Instructions / Assembly

12 MM571W / MM572W Installation Instructions MM571W / MM572W Installation Instructions 13
● Remove the operator from the gate post
and gate brackets.
● Swing the gate to the open position.
● With the gate fully open, install the
closed position stop plate on the gate
opposite the operator (hardware not
included).
● Do not fully tighten hardware until after
the next step.
INSTALLING THE CLOSED POSITION STOP PLATE / PUSH-TO-OPEN
T
V
L
L
P
N
N
S
S
● Secure the gate bracket with the
supplied hardware as shown.
● Once the gate post and gate
brackets are installed, reattached
the operator arm.
● Ensure the operator arm is
level, adjusting the post bracket
location if necessary.
● Once level, ensure all hardware
is tight.
● Remove excess bolt length with a
hacksaw.
H
1
1
2
PUSH-TO-OPEN OPERATOR MOUNTING
Step 10
Step 1
Step 2Step 11
● Swing the gate to the closed position,
and adjust the closed position stop plate
against the fence post.
● Tighten the mounting hardware.
● With the gate in the closed position,
reinstall the operator arm.
Your Property Your Property
Note: For MM572W installations, the closed position stop plate should be installed on the leading edge of the PRIMARY gate leaf,
and adjusted to close against the leading edge of the SECONDARY gate leaf.