Instructions / Assembly

6 Diamond Dual Instruction Manual
PUSH-TO-OPEN installation instructions begin on page 20.
Example of an installation on a chain link fence:
IMPORTANT: To achieve the most efficient leverage for the gate opener and ensure long trouble free
service, the gate opener needs to be installed within the following parameters.
The diagrams below show the optimum positions for the gate opener arm in relation to the gate in the
open and closed positions. Be sure the position of the gate opener and brackets allows for 2" of clearance
between the gate and the opener in both the open and closed positions.
If the gate post is larger than 6" the
Post Pivot Bracket can be removed
and the center hole of
the Post Bracket
can be the
mounting point
for the gate
opener.
Center hole of
post bracket
Gate in the
CLOSED POSITION
Pinch Area
2" minimum
MAX 15"
Gate in the
OPEN POSITION
Pinch Area
2" minimum
Installation Overview for Pull-To-Open Gate
Gate Swings Evenly and Freely
Hung Firmly and Plumb
PVC conduit (not included)
to protect second opener
power cable and low voltage wire
from lawn mowers and weed eaters.
Post Bracket Assembly
Control Box with Battery
Gate Bracket
MASTER Gate Opener
Concrete Poured
Around Gate Post
Run 1000' (max.) of low
voltage wire to control
box from transformer
(wire not included).
6' Power Cable
Closed Position Stop Plates
120 Volt Indoor
Transformer
(surge protector
not supplied)
SECOND Gate Opener