Installation Guide

16 MM571W / MM572W Installation Instructions MM571W / MM572W Installation Instructions 17
CONNECTING THE OPERATOR(S) AND BATTERY CONNECTING THE OPERATOR(S) AND BATTERY
GRN
WHT
BAT+
RESET
BAT–
GRN
WHT
RED BLU
RED BLU COM COM
AUX V+ AUX V-
LOCK V+ LOCK V-
PRIMARY
SECONDARY
LOCK AUX
SW1
SW2
SECURE SEALING NUT
B
SEALING NUT
● Remove the sealing nut from one of
the cable glands on the bottom of the
control box.
● Feed the operator wiring harness
through the sealing nut.
● Insert the wire harness through the
cable gland into the control box at
least 3” to allow connection to the
operator wiring terminals.
● Secure the cable in place by
tightening the sealing nut.
Correct
Wrong Wrong
● Locate the PRIMARY operator wiring
terminals, and insert the wires into
the corresponding color terminals.
● Tighten the screw terminals ensuring
the wires are captured correctly as
shown.
Step 1 Step 3
Step 2 Step 4
C
GRN
WHT
BAT+
AUTO
CLOSE
RESET
PULL
STAGGER
WARNING
BAT–
GRN
WHT
BRN
ORG
BRN
ORG
RED BLK
RED BLK COM COM CYCL SAFE EXIT
SHDW
AUX V+ AUX V-
LOCK V+ LOCK V-
CLOSE EDGE OPEN EDGE
PRIMARY
SECONDARY
LOCK AUX
SW1
SW2
PUSH
12345
+
TERM6
GRN
WHT
BAT+
BAT–
GRN
WHT
BRN
ORG
BRN
ORG
RED BLK
RED BLK
AUX V+ AUX V-
PRIMARY
SECONDARY
SW1
SW2
TERM6
Battery Power Access
● Connect the battery power wires:
Red to Red (BAT+) and Black to
Black (BAT–).