Installation Guide

16 MM562 Installation Instructions

Mounting the Master Opener

Attach the opener to the securely bolted post bracket assembly and gate bracket using clevis pins, bushings, and hairpin clips,

or the optional Pin Locks (FM133). Verify that the opener is level and adjust the post bracket assembly if necessary.

Installing the Second Opener

Install the second opener on the remaining gate leaf by repeating the same process for installing the Master Opener starting

on page 12 through page 16.

NOTE: You will need to run the Second Opener power cable and any hard wired sensor or photo beam wires under the

driveway to the control box.

After you have mounted the second opener, proceed to Installation of the Closed Position Stops on the next page.

Level Opener

Gate In Open Position

LEVEL horizontal cross member

Post Bracket Assembly

bolted to fence post

Clevis Pin, Bushing, and Hairpin Clip

Gate Bracket bolted

to gate cross member

Fence Post