Product Manual

MM562 Installation Instructions 37
15
FUSE
BAT T +
BAT T -
1 2 3 4
ON
STATUS
LEARN RMT
RECEIVER
LEARN
MAST LIMIT
LEARN
2ND LIMIT
S3
S4
ALM
S2
OFF
SOFT START OFF
WARNING OFF
OPEN PULL
2ND OPEN DLY.
MODE1 OFF
MODE2 OFF
ON
ON
PUSH
SIMULT.
ON
ON
120 MIN MAX
CHARGING
POWER IN
GTO RCVR.
WHT
BLU
BRN
ORG
RED
BLK
GRN
WHT
BLU
BRN
ORG
RED
BLK
GRN
COM
GRN
BLK
RED
CYCLE
SAFETY
EXIT
SHADOW
OPEN
EDGE
COM
LOCK
PWR
AUX
R LY
POWER
INPUT
CONTROL OUTPUTS
MASTER OPERATOR2ND OPERATOR
CONTROL INPUTS
AUTO CLOSE TIME STALL FORCE
CLOSE
EDGE
GTO 18 VOLT
TRANSF. OR
SOLAR PANEL
1 2 3 4 5 6 7
DIAG
PORT
CHARGING
POWER IN
RED LED
GREEN LED
Battery/Power Troubleshooting
POWER IN LED CHARGING LED
ON Steady ON Battery Charging
ON Blinking Battery Fully Charged
ON OFF Test charging circuit, check battery
OFF OFF No AC/Solar Power, check battery
OFF Blinking Check battery, incoming AC transformer or solar
OFF Steady ON Test charging circuit and check incoming AC trans
-
former or solar and check battery
Monthly, test the obstruction and entrapment protection systems.
Monthly, service the gate operator (make sure the power switch is OFF). Clean extended operator arm with a soft, dry clean cloth.
After cleaning, apply a high quality silicon spray to a soft dry cloth and wipe the push/pull tube. DO NOT directly spray the tube!
On all gates weighing 250 lb. or more, routinely grease the ball bearing hinges at least 4 times a year; more frequently if the gates are
near a coastal area.
Monthly, turn off the power switch and disconnect the Mighty Mule and move the gate to make sure the gate is moving freely without
sticking or binding. Lubricate the hinges or repair the gate as required before reattaching the Mighty Mule.
Monthly, check the gate system for potentially entrapments from new landscaping or construction. Eliminate or guard as required.
Monthly, check that the warning signs are mounted on each side of the gate and clearly visible. Replace the signs if they are missing
or damaged.
Replace batteries every 2-3 years and properly recycle old batteries.
MAINTENANCE