Product Manual

MM562 Installation Instructions 33
19” MAX
CLEARANCE DAIGRAM
Step 5
Make sure the control box power switch is OFF. Use a small
screwdriver to move the Number 3 DIP switch from the factory setting
(OFF / Pull-To-Open) to ON for Push-To-Open. Turn power switch
ON. The control board is now congured to push the gate open.
Step 6
Install the second gate opener on the other gate in the same manner.
Then refer to the CONTROL BOARD SETTINGS on page 25 for gate
sequencing and other programming steps before proceeding.
DIP#3
ON Push-to-open operation.
OFF Pull-to-open operation (factory setting).
ON
OFF
1
ON DIP
234
1 2 3 4
ON
OFF
SOFT START OFF WARNING OFF OPEN PULL SLV OPEN DLY. MODE1 OFF
ON ON PUSH SIMULT. ON
120 MIN MAX
AUTO CLOSE TIME STALL FORCE
1 2 3
4
O
N
O
F
F
SO
FT
S
TART
O
F
F
WARNING OFF
OPEN PULL
S
LV
O
PEN DLY.
MODE1 OFF
O
N
O
N
PU
S
H
S
IMULT.
ON
120
MIN
M
A
X
AU
T
O
C
L
OS
E TIME
STALL FORC
1 2 3 4
ON DIP
OFF
OFF
PULL
DLY.
OFF OFF
ON ON PUS SIMU ON ON
120 MIN
Step 4
When you feel that you have the best position for the post pivot bracket in the closed position, insert the 5/16" bolt
through the aligned holes of the post bracket and post pivot bracket to hold it in place. Remove the clevis pin from the
front mount and while supporting the gate opener, swing the gate and gate opener to the open position. With the gate
and gate opener in the open position check the clearance and be sure that the gate opener is not binding at the post
pivot bracket.
If you don't have 2 inches of clearance or the gate opener is binding on the post pivot bracket, remove the 5/16" bolt
and readjust the pivot bracket until you can achieve these important clearances. Make sure to reinstall the bolt and
related hardware as shown in step 1.
With the post pivot bracket in the optimum position for clearance and freedom of movement while maintaining 19 inches
or less on the stroke. Reattach the opener to the gate bracket in the open position and recheck the gate opener level
and make sure the brackets are clamped securely.
5/16” bolt
Post Bracket Assembly
Opener