Product Manual

28 MM562 Installation Instructions
1 2 3 4
ON
OFF
SOFT START OFF
WARNING OFF
OPEN PULL
SLV OPEN DLY.
MODE1 OFF
MODE2 OFF
ON
ON
PUS
SIM
ON
ON
120 MIN
AUTO CLOSE TIME STALL FO
1
2 3 4
O
N
OFF
S
OFT START OFF
WARNING OFF
OPEN PULL
S
LV
O
PEN DLY
.
MODE1 OFF
MODE2 OFF
O
N
O
N
P
U
S
S
I
M
ON
O
N
120
MIN
O CLOSE TIME
S
TALL F
O
O
S
M
TO
O
1 2
ON
ON
ON
0MIN MAX
E STALL FORCE
MIN MAX
STALL FORCE
Setting Dual Sense Detection
Do not use the Dual Sense Stall Force adjustment to
compensate for a gate that is sticking or binding. Excessive
Stall Force may cause damage to the gate operator or
gate system or Injury or Death.
The Stall Force adjustment controls the amount of
force the opener will apply against an obstruction
before it stops and reverses direction. The
adjustment on the control board operates like a
volume control on a radio. It controls the amount
of force the opener will apply to an obstruction before
it automatically reverses direction.
The Stall Force adjustment is located on the control
board. Turn the “STALL FORCE” arrow in the center of the
potentiometer with small flat head screwdriver. Adjust the
sensitivity from the MINIMUM position up to the point where the
gate operates without obstructing from its own weight or the wind
conditions in your area.
NOTE: You may need to increase the stall force in cold weather due to
increased resistance from gate hinges. However, the adjustment must remain
as near to minimum as possible and when the weather improves decrease the
setting to the appropriate position.
For safety reason the Dual Sense Stall Force setting on the Mighty Mule control board comes
from the factory set at MIN (minimum). This setting may need adjustment depending on the
size and weight of the gate.
ALWAYS KEEP SAFETY AT THE TOP OF YOUR LIST WHEN ADJUSTING OR SERVICING YOUR
GATE SYSTEM.
CAUTION
Auto Close T
ime Pot
1 2 3 4
ON DIP
STATUS
LEARN RMT
LEARN
MAST LIMIT
LEARN
S3
S2
OFF
SOFT START OFF
WARNING OFF
OPEN PULL
SLV OPEN DLY.
MODE1 OFF
MODE2 OFF
ON
ON
PUSH
SIMULT.
ON
ON
120 MINMAX
AUTO CLOSE TIME STALL FORCE
Setting Auto Close Timer
Turning the pot all the way counter-clockwise will turn auto close
feature off. The minimum time is 3 seconds. The maximum (turn
the pot all the way clockwise) time is 120 seconds.