Product Manual

MM562 Installation Instructions 13
Clevis Pin
Hairpin Clip
Post Bracket Assembly
Rear Mount
Opener
Bushing
Determining the Mounting Position
of the Post Bracket Assembly and the Gate Bracket
Step 3
With the gate in the open position (up to 110º from its closed position) and the gate opener arm fully retracted, adjust the post bracket
assembly and gate bracket until the opener is level. While holding the opener level, use C-clamps to temporarily secure the post
bracket assembly and gate bracket to the fence post and gate.
Step 1
Insert the
3
/8" x 2" bolt through the
center hole of the post brackets and
post pivot bracket as shown. Fasten a
3
/8" lock washer,
3
/8" washer and
3
/8"
nut on the end of the bolt. DO NOT
overtighten the nut because the post
pivot bracket will have to be adjusted
later.
Step 2
Attach post bracket assembly and gate bracket to the opener with the clevis pins and bushings. Secure the clevis pins with
hairpin clips.
Level Opener
Fence Post
Gate In Open Position
Opener Arm Fully Retracted
LEVEL horizontal cross member
Post Bracket Assembly
Gate Bracket
Clevis Pin
Hairpin Clip
Bushing
Gate Bracket
Front Mount
3/8" x 2" Bolt
3/8" Nut
Push-To-Open Bracket
(optional accessory)
Post Bracket
Post Bracket
3/8" Lock Washer
Post Bracket Assembly
3/8" Washer
NOTE: The following steps are
intended for pull-to-open gate
installations. If you are mounting
your gate openers on a push-to-
open gate (e.g., a gate on a sloped
driveway) you will need to purchase
two Push To Open brackets (see
Accessory catalog). Also, see Push-
to-Open Installation beginning on
page 30.