Installation Guide

29 MM560 Installation Instructions
Control Box Settings
3
15
FUSE
BATT +
BATT -
1 2 3 4
ON
STATUS
LEARN RMT
RECEIVER
LEARN
MAST LIMIT
LEARN
SLV LIMIT
S3
S4
ALM
S2
OFF
SOFT START OFF
WARNING OFF
OPEN PULL
SLV OPEN DLY.
MODE1 OFF
MODE2 OFF
ON
ON
PUSH
SIMULT.
ON
ON
120 MIN MAX
CHARGING
PWR IN
GTO RCVR.
WHT
BLU
BRN
ORG
RED
BLK
GRN
WHT
BLU
BRN
ORG
RED
BLK
GRN
COM
GRN
BLK
RED
CYCLE
SAFETY
EXIT
SHADOW
OPEN
EDGE
COM
GTO
TRANSF
LOCK
PWR
AUX
RLY
POWER
INPUTS
CONTROL
INPUTS
MASTER CABLESLAVE CABLE
CONTROL INPUTS
AUTO CLOSE TIME STALL FORCE
CLOSE
EDGE
18 VAC
or
SOLAR
GTO
LOCK
AUX
1 2 3 4 5 6 7
1 2 3 4
ON
STATUS
LEARN RMT
LEARN
MAST LIMIT
S3
S2
SOFT START OFF
WARNING OFF
OPEN PULL
SLV OPEN DLY.
MODE1 OFF
MODE2 OFF
ON
ON
PUSH
SIMULT.
ON
ON
120 MIN MAX
AUTO CLOSE TIME STALL FORCE
4
Replace and secure back cover of the opener remote.
Go to control box. Press and hold the remote and “LEARN RMT”
buttons simultaneously for 5 seconds or until the alarm sounds.
Setting Personal Transmitter Code
Remove back cover of the opener remote. Flip opener remote over. Use small screwdriver to move switch-
es to random positions. If you have more than one transmitter,
now is a good time to set them all with the same code.
1
1 2 3 4 5 6 7 8 9
2
All Mighty Mule transmitters are set to a standard code at the factory and are ready to operate your Mighty Mule
gate opener..
For your safety and security, however, we strongly recommend that you replace the factory setting with your own
personal code. Follow the directions below: