Installation Guide

MM560 Installation Instructions 28
Do not use the Dual Sense Stall Force adjustment to compensate for a gate
that is sticking or binding. Excessive Stall Force may cause damage to the
gate operator or gate system or Injury or Death.
The Stall Force adjustment controls the amount of force the opener will apply
against an obstruction before it stops and reverses direction. The adjustment
on the control board operates like a volume control on a radio. It controls the
amount of force the opener will apply to an obstruction before it automatically
reverses direction.
The Stall Force adjustment is located on the control board. Turn the “STALL
FORCE” arrow in the center of the potentiometer with small at head screw-
driver. Adjust the sensitivity from the MINIMUM position up to the point
where the gate operates without obstructing from its own weight or the wind
conditions in your area.
NOTE: You may need to increase the stall force in cold weather due to
increased resistance from gate hinges. However, the adjustment must remain
as near to minimum as possible and when the weather improves decrease the
setting to the appropriate position.
Turn the “AUTO CLOSE TIME” arrow in the center of the potenti-
ometer with small at head screwdriver. Turning the pot all the way
counter-clockwise will turn the auto close feature off. The minimum
auto close time is 3 seconds. The maximum (turn the pot all the way
clockwise) auto close time is 120 seconds.
15
1 2 3 4
ON
STATUS
LEARN RMT
LEARN
MAST LIMIT
LEARN
SLV LIMIT
SOFT START OFF WARNING OFF OPEN PULL SLV OPEN DLY. MODE1 OFF MODE2 OFF
ON ON PUSH SIMULT. ON ON
120 MIN MAX
AUTO CLOSE TIME STALL FORCE
1
15
FUSE
BATT +
BATT -
1 2 3 4
ON
STATUS
LEARN RMT
RECEIVER
LEARN
MAST LIMIT
LEARN
SLV LIMIT
S3
S4
ALM
S2
OFF
SOFT START OFF
WARNING OFF
OPEN PULL
SLV OPEN DLY.
MODE1 OFF
MODE2 OFF
ON
ON
PUSH
SIMULT.
ON
ON
120 MIN MAX
CHARGING
PWR IN
GTO RCVR.
WHT
BLU
BRN
ORG
RED
BLK
GRN
WHT
BLU
BRN
ORG
RED
BLK
GRN
COM
GRN
BLK
RED
CYCLE
SAFETY
EXIT
SHADOW
OPEN
EDGE
COM
GTO
TRANSF
LOCK
PWR
AUX
RLY
POWER
INPUTS
CONTROL
INPUTS
MASTER CABLESLAVE CABLE
CONTROL INPUTS
AUTO CLOSE TIME STALL FORCE
CLOSE
EDGE
18 VAC
or
SOLAR
GTO
LOCK
AUX
1 2 3 4 5 6 7
1 2 3 4
OFF
SOFT START OFF WARNING OFF OPEN PULL SLV OPEN DLY. MODE1 OFF MODE2 OFF
120 MIN
AUTO CLOSE TIME STALL FORCE
1
Control Box Settings
Setting Dual Sense Detection
Setting Auto Close Timer
For safety reason the Dual Sense Stall Force setting on the Mighty Mule control board comes from the factory set at
MIN (minimum). This setting may need adjustment depending on the size and weight of the gate.
ALWAYS KEEP SAFETY AT THE TOP OF YOUR LIST WHEN ADJUSTING OR SERVICING YOUR GATE SYSTEM.
CAUTION