Installation Guide

MM560 Installation Instructions 22
10’
Max
1
Install Receiver within 10 ft of control box (longer lengths
available - call us). NOTE: NEVER splice receiver cable. DO
NOT run cable through metal conduit because the receiver
signal range will decrease. DO NOT run cable through conduit
containing AC wire. DO NOT place receiver within 3 feet of AC
power.
2
W
W
Check Receiver/Remote signal reception in mounted position/OK—
secure Receiver in position to fence or post. NOTE: If mounting
on metal fence, mount receiver on a piece of wood. Mounting the
receiver on metal can cause interference and the receiver may not
work properly. DO NOT mount upside down.
Control Box Installation
Receiver Installation
Tips
1. Mount the receiver high and above any obstructions; fence
pickets, column caps, etc.
2. If radio control seems limited try moving the receiver 1-2 feet
in each direction to reduce radio noise “dead spots”.
NOTE: Once you have completed the installation, you may need to relocate the receiver to
get better distance.
Consider the following when mounting the receiver:
• Standard receiver cable length is 10 feet (receivers with a longer cable are available as special
order items; call the Mighty Mule Sales Department). NEVER splice receiver cable!
• Run the cable through PVC conduit to protect it from damage.
• DO NOT run cable through conduit containing AC wire.
• DO NOT place receiver within 3 feet of AC power.
• DO NOT coil excess cable or store it in the control box.
• Do not mount upside down.
• The receiver range can vary depending upon weather, topography, and external interference.