Installation Guide

ManualsBrandsMighty Mule ManualsAutomatic Gate OpenersSmart Dual Gate Opener Brings Unrivaled Convenience with Smart Features that Allow Control from Anywhere

6 MM371W / MM372W Installation Instructions MM371W / MM372W Installation Instructions 7

● Secure the gate bracket with the

supplied hardware as shown.

● Once the gate post and gate

brackets are installed, reattached

the operator arm.

● Ensure the operator arm is level,

adjusting the post bracket location

if necessary.

● Once level, ensure all hardware is

tight.

● Remove excess bolt length with a

hacksaw.

Fence Post: MM571W

Leading Edge of

Second Gate: MM572W

Fence Post: MM371W

Leading Edge of

Second Gate: MM372W

● Remove the operator from the

gate post and gate brackets.

● With the gate fully open, install

the closed position stop plate

(hardware not included).

● Do not fully tighten hardware

until after the next step.

● Swing the gate to the closed

position, and adjust the closed

position stop plate against the

fence post.

● Tighten the mounting hardware.

● Return the gate to the open

position and reinstall the operator

arm.

● To complete the pull-to-open

installation, proceed to page 14.

INSTALLING THE CLOSED POSITION STOP PLATE / PULL-TO-OPEN

Step 10

Step 1

Step 11

Step 2

PULL-TO-OPEN OPERATOR MOUNTING

Your Property Your Property

Installing the Secondary Operator (MM372W only):

Install the secondary operator on the remaining leaf by repeating the same process illustrated in steps 1-11 above.

Note: You will need to run the secondary operator power cable and any hard wired accessory wires under the driveway to the

control box (use of conduit is recommended). Locating the primary operator on the gate leaf closest to the power source or desired

solar panel location is recommended. See front page of this manual for a complete installation example.

After you have mounted the second operator, proceed to Installation of the Closed Position Stop Plate on the following pages.

Note: For MM372W installations, the closed position stop plate should be installed on the leading edge of the PRIMARY gate leaf,

and adjusted to close against the leading edge of the SECONDARY gate leaf.