Instructions / Assembly

8 MM371W / MM372W Installation Instructions MM371W / MM372W Installation Instructions 9
PUSH-TO-OPEN OPERATOR MOUNTING PUSH-TO-OPEN OPERATOR MOUNTING
G
V
T
O
L
G
11”
S
S
E
F
B
N
N
G
V
T
O
L
G
11”
S
S
E
F
B
N
N
Step 1
Step 2
● Assemble the gate post bracket subassembly
as shown with the Push-to-Open pivot bracket
(FM148). Must be purchased separate.
● Attach the gate post bracket subassembly and
gate bracket to the operator as shown.
L
e
v
e
l
horizontal
cros
s
me
m
be
r
L
ev
e
l op
e
ner
Gate in Closed Position
Gate Bracket
Post Bracket Assembly
Step 3
Step 4
● With the gate in the CLOSED
position, use clamps to secure
the operator to the gate post and
center cross member of the gate.
● Ensure that the operator is level.
● With the operator arm temporarily
secured to the gate, check to
ensure there is at least 2 inches
of clearance between the operator
arm and gate. (See illustration in
Step 4 below).
20” MAX
CLEARANCE DIAGRAM
● Disconnect the operator arm from the
gate bracket.
● While supporting the operator, swing
the gate and operator to the OPEN
position.
● Check for recommended clearances
and binding as shown.
● Ensure that the necessary arm stroke
does not exceed 17 inches.
● Make adjustments to the
mounting brackets to achieve the
recommended clearances.
TIP: Turning the pivot bracket over
gives more hole alignment options for
the gate post pivot bracket assembly.
Your Property Your Property
Push-to-Open pivot
bracket (FM148)