Installation Guide

Mighty Mule MM360 Installation Instructions 21
ON/OFF
– o
Battery Harness Wires
Transformer Wires
Receiver Wires
Accessory Wires
Neatly arrange all
wires to lay flat as
they come out of
the opener.
Wire Routing
Routing Pin
ON/OFF
ON/OFF
Receiver Wire
Battery Harness Wire
Battery Harness
In-Line 15 Amp Fuse
(included)
Battery Harness
Connectors
5
1
The battery harness wire has an
in-line fuse that must be placed
inside the battery box when
connecting the battery to the
opener. The illustration to the
right shows the best placement
for the battery harness wire and
connector inside the arm.
The wires from the battery harness, receiver, transformer or
solar panel, and any accessories that have been installed will
be routed down the sides of the opener and out the strain
relief slot in the back of the opener.
It is IMPORTANT that the wires lay flat and run inside the
routing pins at the back of the opener and out the strain
relief slot without being pinched when
the control board access cover is
replaced. See the illustrations to the
right and below.
IMPORTANT: Detailed Wire Routing Diagrams