Manualshelf

Product Manual

ManualsBrandsMighty Mule ManualsAutomatic Gate OpenersMedium Duty Single Swing Automatic Gate Opener Solar Saver Package
31323334353637383940
Mighty Mule MM360 Installation Instructions 27
1
ON
234
15
CHARGING
POWER
STATUS
RF
PULL-PUSH
MODE1
MODE2
LOCK/BEACON
OFF 120
MIN MAX
STALL FORCE
CLOSE TIME
SET
LIMIT
LEARN
REMOTE
AUX OUT
SOLAR
PANEL
18VAC
RECR
GRN
BLK
RED
EXIT
SAFETY
EDGE
CYCLE
COMMON
LINK
MINMAX
STALL FORCE
1
ON
234
15
CHARGING
POWER
STATUS
RF
PULL-PUSH
MODE1
MODE2
LOCK/BEACON
OFF120
MIN MAX
STALL FORCE
CLOSE TIME
SET
LIMIT
LEARN
REMOTE
AUX OUT
SOLAR
PANEL
18VAC
RECR
GRN
BLK
RED
EXIT
SAFETY
EDGE
CYCLE
COMMON
LINK
OFF 120
CLOSE TIME
Set Auto-Close Time
The Auto-Close determines how long the gate will remain open before
it automatically closes. The factory setting is OFF. Use a small flat blade
screwdriver, you can adjust the settings to OFF, or from 3 to 120 seconds.
NOTE: Auto-Close timer is disabled (gate will not automatically close) if
gate is not at the fully open position.
Setting Dual Sense Detection and Auto Close Timer
Do not use the Dual Sense Stall Force adjustment to compensate for a gate that is sticking
or binding. Excessive Stall Force may cause damage to the gate operator or gate system
or Injury or Death.
The Stall Force adjustment controls the amount of force the opener will apply against
an obstruction before it stops and reverses direction. The adjustment on the control
board operates like a volume control on a radio. It controls the amount of force
the opener will apply to an obstruction before it automatically reverses direction.
The Stall Force adjustment is located on the control board. Turn the “STALL
FORCE” arrow in the center of the potentiometer with small flat head screwdriver.
Adjust the sensitivity from the MINIMUM position up to the point where the gate
operates without obstructing from its own weight or the wind conditions in your
area.
NOTE: You may need to increase the stall force in cold weather due to increased
resistance from gate hinges. However, the adjustment must remain as near to
minimum as possible and when the weather improves decrease the setting to the
appropriate position.
For safety reason the Dual Sense Stall Force setting on the Mighty Mule control board comes
from the factory set at MIN (minimum). This setting may need adjustment depending on the
size and weight of the gate.
ALWAYS KEEP SAFETY AT THE TOP OF YOUR LIST WHEN ADJUSTING OR SERVICING YOUR
GATE SYSTEM.
CAUTION