Product Manual

26 Mighty Mule MM360 Installation Instructions
Setting the Closed Position Limit
ON/OFF
Turn the power switch on
to the ON position
For PULL-TO-OPEN Installation
Step 1
Power switch is on, gate
is in the OPEN position,
opener arm fully
retracted.
Step 2
Press the transmitter to
activate opener arm.
The gate will
begin to CLOSE.
Step 3
When the gate reaches
the desired CLOSED
position, press
the transmitter
to stop the gate.
Step 4
With the gate at
the correct position,
program the closed limit
setting by pressing and
holding SET LIMIT
for 5
seconds.
Gate in
OPEN
Position
Gate
Closing
Gate
Closed
Gate in
OPEN
Position
ON/OFF
Step 5
Press the transmitter
again to allow the gate to
return to the fully
OPEN position.
The gate closed position is now programmed.
If you set the limit at the wrong position:
press your transmitter to return the gate to
the fully opened position, then press and
hold the SET LIMIT button for 5 seconds. This
will clear the memory for the closed limit
position. Repeat Steps 1-5.
1
ON
234
15
CHARGING
POWER
STATUS
RF
PULL-PUSH
MODE1
MODE2
LOCK/BEACON
OFF 120
MIN MAX
STALL FORCE
CLOSE TIME
SET
LIMIT
LEARN
REMOTE
AUX OUT
SOLAR
PANEL
18VAC
RECR
GRN
BLK
RED
EXIT
SAFETY
EDGE
CYCLE
COMMON
LINK
MINMAX
STALL FORCE
SETTING THE CLOSED POSITION LIMIT
NOTE: If gate
stops and
reverses you may
need to adjust the Stall Force (see page 27).
NOTE: All transmitters come pre-programmed
from the factory. However, if the transmitter did not
activate the gate, follow steps 1 to 3 on page 28.