Product Manual

12 Mighty Mule MM360 Installation Instructions

Tools and Materials

Tools Needed:

• Power Drill

• Open End Wrenches —

/2" and

/16"

• Adjustable Wrench

•

/8" Drill Bit

• Hacksaw or Heavy Duty Bolt Cutters

• Small Flat Bladed Screwdriver

• Large Phillips Screwdriver

• Tape Measure

• Level

• Wire Strippers

• C-Clamps — small, medium, and large

• Center Punch

• Hammer (for center punch)

• Extra person will be helpful

Materials You May Need for the Installation:

These items are NOT included with the gate opener kit. Some of these items can be purchased separately.

• Low voltage wire [RB509] will be needed to run from the transformer to the opener control board; length

depends upon the distance between the transformer power supply and the control arm.

• If your gate is more than 1000' away from an AC power source you will need to use at least one 5 Watt solar

panel [FM121] to charge the 12 Volt battery.

• PVC conduit for protecting wiring.

• Push-To-Open Bracket [FM148] is required if gate opens out from property.

• Materials to reinforce thin walled tube or panel gates (see page 14).

• Depending on the type of gate, a horizontal cross member or mounting plate may be needed to mount the front

of the opener and gate bracket to the gate.

• Some installations may require mufﬂer clamps for the gate bracket (see page 14).

• Surge protection for transformer.

• Weather proof outlet and cover is required if transformer is plugged into outside outlet.

• Some types of installations require U-Bolts for closed position stop plate.

Note: Not all tools shown.