Full Product Manual

xii MM271 Installation Instructions MM271 Installation Instructions xiii
E
A
B
C
D
F
Gate Grounding
● For reference only.
Cooper Clad Ground Rod (not included)
Use an 8 foot, 5/8 inch ground rod, positioned
two feet or less from the post and 2 inches or
less above the ground. Available at local home
center or hardware stores.
NOTE: No grounding system absolutely
protects against lightning strikes. If installed
correctly, a grounding system will help
minimize damage to your gate operator.
● The gate must be plumb, level, and swing freely on its hinges.
● The gate must move throughout its arc without binding or dragging on the ground.
● Wheels must NOT be attached to the gate.
● Gates over 250 lb. should have ball bearing hinges with grease ttings.
● Post must be secured in the ground with concrete (minimizes twist/ex when the operator is activated).
● Make sure there is a stable area for mounting the gate bracket (this may require the addition of a horizontal or
vertical cross member).
● We recommend you position the operator near the center-line of the gate to keep the gate from twisting and
exing, and to avoid back-splash from rain.
Copper clad ground rod
(not included)
Ground
Ground
2 Inches or
Less above
ground
Copper ground
rod clamp
Copper Single
Conductor Lug
3/16” Drilled
Pilot Hole
6 ft. deep
or more
Metal gate post
Metal Gate Post
Gate Opener
Control Box
2 ft. or Less
from post
IMPORTANT: CHECK FOR PROPER GATE INSTALLATION
CHECK EXISTING GATE SIZE AND MATERIAL
• Gate size: Up to 12 feet and up to 300 lbs • Type of gate material: Vinyl, aluminum, chain link,
farm tube, wrought iron, wood.
Not rated for use on solid surface gates.
A - Level
B
- Plumb
C
- Free Swinging
D
- Secured Posts in
Concrete
E - Center line Mounting
F - Good Working Hinges (ball bearing
hinges are recommended on gates
over 250 pounds)
3/8” x 1-1/2” Clevis Pin (2)
3/8” x 8” Bolt (2)
8” Nylon Cable Tie (6)
Control Box
Gate Bracket
Post Pivot Bracket
Post Bracket
Transformer Warning
Signs (2)
Closed Position
Stop Plate
Transmitter (1)
3/8” x 1-1/2” Bolt (1)
5/16” x 1-1/4” Bolt (1)
3/8” Washer (7)
5/16” Washer (1)
3/8” Nut (5)
5/16” Lock Nut (1)
Hairpin Clip (2)
2” Mounting Screw (3)
A
F
Operator Arm
B
G
I
E
C
H
D
J K
N
L
Q
S
O
P
M
R
U
T
3/8” Lock Washers (5)
V
3/8” x 2-3/4” Bolt (2)
ITEMS INCLUDED