Product Manual

MM260 Installation Instructions 13
Monthly, test the obstruction and entrapment protection systems.
Monthly, service the gate operator (make sure the power switch is OFF). Clean extended operator arm with a soft, dry clean cloth. After
cleaning, apply a high quality silicon spray to a soft dry cloth and wipe the push/pull tube. DO NOT directly spray the tube!
On all gates weighing 250 lb. or more, routinely grease the ball bearing hinges at least 4 times a year; more frequently if the gates are
near a coastal area.
Monthly, turn off the power switch and disconnect the Mighty Mule and move the gate to make sure the gate is moving freely without
sticking or binding. Lubricate the hinges or repair the gate as required before reattaching the Mighty Mule.
Monthly, check the gate system for potentially entrapments from new landscaping or construction. Eliminate or guard as required.
Monthly, check that the warning signs are mounted on each side of the gate and clearly visible. Replace the signs if they are missing or
damaged.
Replace batteries every 2-3 years and properly recycle old batteries.
Audible Feedback
Symptom Diagnosis Check:
1 or more short beeps
upon power up
Circuit Board Powered
Up & Ready
• Normal Operation
Rapid beeping Circuit Board Senses an
Obstruction
• Path of Gate
• Gate for Level and Plumb
• Stall Force Adjustment
• Disconnect Obstruction Detection Devices
1 beep every 20 seconds
off
Low Battery Condition Transformer or Solar Panel Voltage
• Charge the battery if solar conditions have been poor
• Battery Harness Connections
• Battery Under Load
2 beeps every 2 seconds Position sensor is short
circuit.
Arm Power Cable for Damage
1 beep every 2 seconds off Position sensor is open
circuit.
Arm Power Cable for Damage
1 beep when attempting to
run the gate
Blown fuse
Battery is low or damaged
Loose Connection
Check and replace fuse
Test battery voltage
Check all connections
If your gate opener does not function properly after it is installed, use this guide before calling the GTO Service Department.
Additional information can be found online 24 hours 7 days a week at the
GTO Tech Wizard (support.gtoinc.com/Support/TroubleShooter.aspx)
TROUBLESHOOTING GUIDE
MAINTENANCE