Product Manual

MM260 Installation Instructions 1
1
2
3
5
5
S
V
H
I
Y
X
X
F
S
M
Q
B
Q
3
1. KEEP CLEAR! Gate may move at any time.
2. Do not allow children to operate gate or
play in gate area.
3. This gate is for vehicles only. Pedestrians
must use a separate entrance.
Moving Gate Can Cause
Injury Or Death
WARNING
!
Thin Walled
Tube Gate
Gate
Bracket
1” x 6” Wood Reinforcement
Panel
Gate
Gate
Bracket
Wood or Metal
Reinforcement
(not supplied)
Mounting Plate
Created for
Decorative Gate
(required but not
supplied)
Remove excess bolt length
with hacksaw or bolt cutters
FRONT VIEW
SIDE VIEW
Reinforcement and Gate Bracket Mounting
Muffler Clamp
(not supplied)
Gate
Bracket
1. KEEP CLEAR! Gate may move at any time.
2. Do not allow children to operate gate or
play in gate area.
3. This gate is for vehicles only. Pedestrians
must use a separate entrance.
Moving Gate Can Cause
Injury Or Death
WARNING
!
2
4
1
2
1
1" Min. - Pinch-Point Clearance
Top View
1" Min.
7”–13"
2
1
Closed
Position
Open
Position
stroke
Attach opener to gate and post bracket and secure with re-
quired hardware.
Assemble post bracket parts.
With Gate in OPEN position, using clamps, secure opener to
gate post and center cross member of gate.
Recommended reinforcement and gate bracket mounting
examples.
Swing gate and opener arm to the CLOSED position-check clearance/
binding by inspecting alignment. Arm stroke should be a minimum
of 7” and maximum of 13”. TIP: Turning the pivot bracket over gives
more hole alignment options for the post pivot bracket assembly.
Remove clevis pin from the gate bracket and support loose
opener.
GATE OPENER INSTALLATION