Installation Guide

Adding Additional Base Units
Batteries must be installed and the units turned ON.
1. Press and release the “ID SET” button on the Keypad.
2. Press the number on the Keypad that corresponds to
the Intercom you are adding or changing. You will hear
the number of beeps corresponding to the number you
pressed.
For Example: If you are adding a third Intercom to the
system PRESS #3. The Keypad will beep THREE times.
3. Press the “ID SET” button on the Intercom approximate-
ly 2 seconds then release. You will hear THREE beeps
from the Intercom and THREE beeps from the Keypad,
which means the ID Codes are set.
IMPORTANT: Base units need to be placed at least 10
feet apart to prevent interference.
RELAY
OUTPUT
AC/DC
POWER IN
123456789
+
0
–
ID SET
+
–
–
–
+
+
–
+
RESET
JUMPER
ID SET button
ID SET
VOLUME
POWER
OFF
ON
Keypad - Inside
Intercom - Bottom
1 2
ABC
3
DEF
4
GHI
5
JKL
6
MNO
7
PRS
8
TUV
9
WXY
0
CALL
STATUS
PROGRAM
CALLING
GRANTED
Keypad - Front
ID SET button
If you have purchased additional Base units to
enhance your system, each additional unit’s ID
Code must be programmed into the Keypad so
they can communicate. Follow the steps below to
set the ID codes.
Test the System
IMPORTANT: The Base unit and the Keypad can not be within 30 feet of each other when operating. If units are closer
than 30 feet the signal will be inconsistent as well as emit speaker feed back. Also, multiple Base units must be no closer
than 10 feet from each other to prevent interference.
Have someone press the CALL button on the keypad at the gate. When the base unit inside the house rings, press
the ANSWER button and talk to the person at the gate to check the connection and range. Then press the GRANT
PERMISSION button and have the person at the gate press any key on the keypad to activate the gate.
2