Installation manual

20
Step 19
Select the 110 Volt electrical outlet into which you will plug the transformer. Lay the low voltage wire in a trench following
a path from the selected electrical outlet to the control box. Wires coming up from the ground should be run through PVC
conduit to protect them from lawn mowers, weed eaters, and grazing animals. Be sure to bury the wire laid in the trench.
Low Voltage Wire

GTO indoor
Transformer
(surge protector 
not supplied)
®
E
-
Z
G
A
T
E
O
P
E
N
E
R
250
S
E
R
I
E
S
C
a
n
C
a
u
s
e
I
n
ju
r
y
o
r
D
e
a
t
h
M
O
VIN
G GATE
L
I
S
T
E
D
®
U
S
Step 20
Bring enough wire up through the
PVC conduit to allow for gate
movement from open to closed
position. See example right.
RED wire to POSITIVE (+) terminal
BLACK wire to NEGATIVE (–) terminal
RED
BLACK
Step 18
Make sure the opener power switch is in the OFF
position. Connect the RED battery wire to the
POSITIVE (+) terminal on the battery. The
BLACK wire should already be connected to the
NEGATIVE (–) terminal from the factory.
Replace the Battery Access Cover.
IMPORTANT: Pay close attention to the color
of the wires. If the wires are connected
incorrectly, the control board will be damaged.
TIP: Apply a small dab of petroleum jelly to the
terminals to help prevent corrosion.
Step 17
Remove the Battery Access Panel on
the bottom of the opener arm.
Battery 
Access Panel
O
N
OFF
®
E-Z G
ATE OPENER
250
U
L
3
2
5
S
E
R
I
E
S
Can Cause Injury or Death
MOVING GATE
L
I
S
T
E
D
®
U
S
Connecting the Battery
Connecting the Transformer