Installation manual

18
Mounting the Receiver
Consider the following when mounting the receiver:
• Standard receiver cable length is 10 feet (receivers with a longer cable are available as
special order items; call the GTO Sales Department). NEVER splice receiver cable!
• DO NOT run cable in conduit containing AC wiring.
• The receiver range can vary from 50 to 100 feet depending upon weather, topography,
and external interference.
FCC Regulation
This device complies with FCC rules Part 15. Operation is subject to the
following conditions:
1. This device may not cause harmful interference.
2. This device must accept an interference that may cause undesired
operation.
Transmitter distance may vary due to circumstances beyond our control.
NOTE: The manufacturer is not responsible for any radio or TV
interference caused by unauthorized modifications to this equipment.
Such modifications could void the user’s authority to operate the
equipment.
Wiring the Receiver
Step 15
The receiver wire has three leads. Connect the RED,
BLACK and GREEN leads to the RADIO
TERMINAL BLOCK on the control board. Insert
each wire into its corresponding terminal block and
secure the wires by pressing down on the white
terminal block tabs until they lock in place. (shown
below).
EDGE RED BLK GREEN SAFETY
CYCLE
RADIO
18 VAC
INPUT
SET
CLOSE
LIMIT
COMMON
15 AMP
Wire from Receiver
RED
BLACK
GREEN
Close and lock
wire in place.
Insert wire into
terminal block.
No-Tool Terminal Blocks
1
2
Step 16
Use the screw or ty wrap provided to secure the receiver in place.