Installation manual

12
Installation of Mounting Hardware
The position of the post bracket determines the leverage and efficiency of the opener. The post bracket position also sets the
clearance between the opener and gate in the open and closed positions.
The curved design of the post bracket works well for installations on round and square fence posts. Because the post bracket
carries the entire thrust of the active opener, bolts that completely penetrate the fence post must be used.
On wooden posts, place a metal plate or washer
(not supplied) between the nuts and the fence
post to prevent the thrust of the opener from
pulling the bolts and washers out of the wood.
NOTE: A fence post smaller than 6" in diameter
or 6" square should be made of metal instead of
wood so that it will remain stable while the
opener is moving the gate.
On round posts of 6" diameter or larger, the post pivot bracket may not
be necessary for the installation. In this instance, the two post brackets
are mounted by themselves.
IMPORTANT:
We strongly recommend using steel pipe, thick walled PVC pipe, wood or metal to reinforce thin walled tube
gates or wood to reinforce panel gates as shown. These reinforcement methods will prevent damage to the opener
and gate when the opener is installed.
Recommended Reinforcement Examples
Post 
Bracket
Post 
Pivot Bracket
Metal Plate
Wooden Post
Post
Bracket
Post
Pivot Bracket
Metal Plate
Wooden Post
4 1/2"
4 1/2"
Center of Gate Hinge
Pull-to-Open Installation
Larger than 6" diameter post
GATE
Thin Walled Tube Gate
PVC or Steel Pipe Cut in Half
Gate Bracket
Gate Bracket
Wood or Metal
Reinforcement
Gate Bracket
Panel Gate
1" x 6" Wood Reinforcement
(not supplied)
(not supplied)