Installation manual

22
Step 9
Plug the transformer into the electrical outlet. (Use of a surge
protector with the transformer is
strongly
recommended.)
Step 8
At the AC outlet strip
1
/
2
" of insulation from the ends of
the low voltage wire. Attach these stripped ends to the
transformer terminals.
A dab of household petroleum jelly on each terminal will
help prevent corrosion.
We suggest crimping a spade tongue terminal (
not
provided
) to the end of each wire before attaching it to
the transformer.
Make sure the exposed wires do not touch each other!
SURGE PROTECTOR
Transformer
Step 7
Strip
3
/
16
" off the ends of the low voltage
wire and twist tightly. Insert these ends to
the
18 VAC
terminal block located on the
control board (
see illustration at right
). The
wires can be inserted into either terminal
regardless of color.
Be certain not to let
the exposed wires touch each other!
Tighten set screws against exposed end of
wires. A dab of household petroleum jelly
on each terminal will help prevent corrosion.
Spade Tongue Terminal
(not provided)
1
ON
2 3
4
15
CHARGING
POWER
STATUS
RF
PULL-PUSH
MODE
1
MODE
2
LOCK/BEACON
OFF 120
MIN MAX
STALL FORCE
CLOSE TIME
SET
LIMIT
LEARN
REMOTE
AU
X
OUT
SOLAR
PA
NEL
18VAC
RCVR
GRN
BLK
RED
EXIT
SAFETY
EDGE
CYCLE
COMMON
LINK
Low Voltage Wire
from Transformer