Installation manual

19
Step 2
Place the 12 Volt automotive or marine type battery and its
weatherproof case within 6 feet of the fence post where the
opener arm is mounted.
Step 3
Attach the 10 foot battery harness wires provided, to the
terminals of the battery. Take care to attach the BLACK wire to
the NEGATIVE terminal and the RED wire to the POSITIVE
terminal. Reverse connection will cause damage to the control
board.
Step 1
With the opener mounted in the upside down position
remove the Control Board Access Panel on the bottom
of the opener arm.
Connecting the Battery
O
N
/
O
FF
O
N
/
O
F
F
Control Board Access Cover
Control Board
Battery Harness
Connector
Receiver Wires
ON/OFF Switch
Step 4
IMPORTANT:
Make sure the power switch on the
opener arm is in the OFF position.
Run the plug end of the Wire Harness wire up to the
opener arm and plug it into the battery harness connector
coming from the control board.
ON/OFF
O
N
/
O
FF
Battery Harness Connector
10 foot Harness
From Batter
y
RED to POSITIVE
BLACK to NEGA
TIVE
Battery Harness
Connector
0
2
10 Foot
Po
wer Cable