Installation manual

24 Rodeo Gear Medium Duty Dual Gate Opener Installation Manual rev 05.7.13
Troubleshooting Guide
If your gate opener does not function properly, use this guide or use the online troubleshooter at
http://support.gtoinc.com before calling the Service Department.
VISUAL AND AUDIBLE DIAGNOSTIC INDICATORS
1. Visual Indicators:
a. Power LED (Green):
  •ON:ACpowerorSolarpowerispresent.
  •OFF:Thereisnoinputpower.
b. Status LED (Yellow): (while unit is running this LED will be OFF)
  •Rapidblinkinginrandompattern:Transmitter318MHzsignalisdetected.
  •ContinuouslyON:Batteryisinfastchargemode.
  •1Blinkevery2seconds:Batteryisinoatchargemode(batteryisfullycharged)
  •OFF:SwitchisintheOFFpositionorthereisnoinputpowerforatleast60seconds.
2. AUDIBLE INDICATOR (ALARM/BUZZER):
a. Beeps upon power up:
  •Thisisnormalselftestwhentheunitisturnedon.
b. Continuous beep after power up:
  •Unithaslearnednewtransmittercode,releasingthetransmitterbuttonwillshutoff
the alarm or…
  •Unithasentered‘LEARNLIMIT’mode,releasingthetransmitterbuttonwillshutoffthealarm.
c. Rapid beeping:
  •Unithasencounteredtwo(2)obstructionswithoutreachingeitherlimit.(Powercycletoresetthealarm)
  •Transmitterwillnotoperatethegate.
  •Alarmwillautomaticallyshutoffafter5minutes;gatewillremaindisableduntilcontrolboxisrestarted.
d. 1 beep every 20 seconds:
  •Lowbatteryisdetected.
e. 1 beep every 2 second:
  •Positionsensorisopencircuit.CalltheServicedepartment.
f. 2 beeps every 2 second:
  •Positionsensorisshortcircuit.CalltheServicedepartment.
g. 1 beep when attempting to activate the opener:
  •Blownfuse.
  •Batteryisextremelylowordamaged.
  •Looseconnectionfrombatterytocircuitboard.
3 . IF THE GATE STOPS AND REVERSES DIRECTION
1. Check the position of the mounting brackets and readjust if necessary.
2. Check the gate for binding or hinge damage.
3. Adjust stall force if necessary.
4. Reprogram closed position limits.