Safety & Operating Instructions

Chapter 6: Chipper Accessories

Shut down the Engine (The flywheel will continue to rotate for a while after the engine is shut off), Wait 5 minutes for the

engine to cool and all moving parts to come to a complete stop, remove spark plug wire and disconnect the negative

battery cable before moving or working on the chipper.

Discharge

Chute

Figure 64

Scroll

Weldment

Extended Top-Discharge Chute

The Extended Top-Discharge Chute enables you to better control the

direction

of the discharged chips and allows you to direct them into a

trailer or truck bed for transport.

Tools Needed:

•

Two 1/2" Wrenches

INSTALLATION

Remove the two Bolts and Locknuts from the Discharge Chute

with two 1/2" wrenches (Figure 64).

Remove the Discharge Chute from the Chipper.

Position the Extended Top-Discharge Chute onto the Chipper with

the Locking pin on the outside (side furthest away from the hopper)

(Figure 65).

Install the two Bolts and Locknuts and tighten with two 1/2" Wrenches.

Figure 65

Extended Top-

Discharge Chute

Bolt and

Locknut

(2 places)

Locking

Bolts and

Locknuts