Safety & Operating Instructions

4. Remove the Tire and replace it with a new wheel assembly.
5. Screw the Castle Nut onto the Axle and tighten it with an
adjustable wrench to seat the Bearings (Figure 61).
6. Back the Castle Nut off and then snug it up to the Bearing lightly.
7. Insert a Cotter Pin through the slots of the Castle Nut and into the
hole in the Axle.
8. Bend the ends of the Cotter Pin with Needle nose Pliers to secure it.
9. Place the Dust Cap onto the Wheel Assembly and secure it by placing
a piece of wood over it and pounding lightly with a hammer until it is
against the lip (Figure 62).
10. Jack the back of the Chipper up and remove the jack Stands.
11. Lower the Chipper to the ground.
12. Check the Tire for proper air pressure of 60 psi maximum in each tire.
Figure 61
Wheel
Assembly
Taper Bearing
Figure 62
Removing and Replacing the Clutch
The design of the Clutch on your machine is for rugged, dependable service; however, it is important to understand the limitations of a
Clutch. The Clutch provides load free starting of the Engine and provides slippage under excessive overloading of the driven application.
These features help protect the Engine from damages such as broken crankshafts and starters. The Shoes and Springs on the Clutch
are normal wear items. If you notice decreased performance of the Clutch, check and replace it if necessary.
The Clutch obtains its power from the Engine RPM. The lower the engagement speed, and the higher the maintained Engine speed, the
more torque the Clutch can transfer to the driven unit. NEVER operate the GRAVITY SELF-FEEDING WOOD CHIPPER Engine at less
than full RPM when chipping.
Note: At engine start-up, the engine of your chipper operates under no load until approximately 1800 RPM, at which speed
the centrifugal clutch engages and begins driving the rotor.
• Do not tamper with the engine’s governor setting. The governor controls the maximum safe operation speed and protects the
engine. Over-speeding the engine is dangerous and will cause damage to the engine and to the other moving parts of the
machine. See your authorized dealer for any engine governor adjustments.
• Become familiar with successful operating conditions and avoid those that can overload and damage the machine.
• Do not overload or attempt to chip material beyond manufacturers recommendation. Personal injury or damage to the
machine could result. Learn to recognize the sound of the machine during an overload condition. Only your operator
experience will tell you how fast you can successfully feed material into the machine.
• If overloading or any other cause jams the machine, stop the machine immediately. If you jam the machine and do not stop
the engine, it can burn the drive belt and/or ruin the clutch. Clutch damage can be costly and it may not be covered under warranty.
For this reason, it is important that you immediately shut off the machine if it becomes jammed.
• The centrifugal clutch on this machine is permanently lubricated and does not require oil or grease. If, after long periods of
use, the drum wobbles excessively, replace the clutch assembly. Always replace shoes and springs in sets. Whenever shoes are
changed, replace all springs.
Dust Cap
Wheel
Assembly
Wheel
Assembly
Taper Bearing
CONTACT US AT www.MacKissic.com 35