Safety & Operating Instructions

ManualsBrandsMighty Mac ManualsChipper(5.75") 420cc Electric Start Wood Chipper

For extra safety and security, you may want to purchase a Lock or

Lock Pin to install into the Latch Assembly of the Tow-Hitch Package

(Figure 32).

Connect the Wire Harness Connector to your Tow Vehicle and ensure

that

your lights on the Chipper are working properly.

Avoid death or serious injury. Do not exceed 45 mph towing this

machine.

Lock or

Lock Pin

Making sure the chipper is securely attached to the vehicle is the

responsibility of the owner/operator. Failure to securely attach the chipper can

cause loss of control of the vehicle or the chipper being separated from

the towing vehicle, resulting in serious injury or death.

Hitch Coupler Adjustment Check

Place the proper size ball in the socket of the coupler and close the

latch

assembly

(Figure 33)

. Verify that the locking trigger is properly

engaged in

its detent.

Pull on the ball and/or coupler, trying to remove the ball from the

socket. If the ball moves more than 1/16" in the coupler’s socket, the

clamp requires adjustment. Follow the proper adjustment procedure in

the following steps.

Hitch Coupler Adjustment

With the proper size ball in the socket of the hitch coupler, close the

latch of the coupler completely (Figure 34). Verify that the locking

trigger is properly engaged in its detent.

Tighten the lock nut on the underside of the coupler until the spring

between the nut and the clamp is fully compressed. Then back off

the lock nut 1/2 turn or just enough that the latch is able to clamp and

unclamp from the ball.

Latch

Assembly

Figure 32

Figure 33

Figure 34

Pull

Locking

Trigger

Ball

1/16"

Movement

Spring

Lock Nut

Ball Clamp