Safety & Operating Instructions

Housing Stu
Attaching the Hopper Assembly
Figure 15
Note: We recommend that you have someone help
you lift the Hopper in place and support it until it is
secured to the Chipper.
Tools Needed:
• One 1/2” Wrench and One Phillips Head
Screwdriver
1. Gather x8 5/16-18 x 3/4" Truss Head Bolts,
x8 5/16-18 Thin Nylon Locknuts, and x8 5/16
SAE washers from your Bolt Bag.
2. Place the Hopper Assembly inside of the
Hopper Neck.
3. From the inside of the Hopper Assembly,
insert a Truss Head Bolt through the holes
(x4 each side of Hopper), place a 5/16 SAE
washer over the protruding bolt threads, and
secure using a Thin Nylon Locknut on the
outside (Figure 15).
Note: The head of the Truss Head Bolt should be
inside of the Hopper creating a smooth inlet for
material feeding.
Hopper Neck
Hopper Assembly
Install Hardware
CONTACT US AT www.MacKissic.com 15