Safety & Operating Instructions

Figure 7
Wires
Tow Bar
Larger Hole
Installing the Tow Bar and Lights for the Highway
Accessory
Note: For easier installation, keep the machine on the pallet and supports until the
Tow Bar is installed.
Tools and Supplies Needed:
• 7/16 Wrench
• Two 1/2" Wrenches
• Two 3/4" Wrenches
• Wire strippers/Cutters
• Stiff Wire with Hooked End
• Cable Ties (Supplied with machine)
1. Insert the ends of the Yellow/Brown and Green/Brown Wires of the
Wire Harness into the Tongue Assembly and down into the Tow Bar
(Figure 7) until they reach the large hole (Figure 8).
2. Pull the ends of the wires through the large Hole by using a stiff wire with a
small hook formed at the end.
3. Continue pulling the Wires through leaving approximately two feet of the
Hook Tool
Figure 8
Tow Bar
Plug end extended beyond the front of the Tongue assembly.
4. Position the Tow Bar under the Base and secure the front Bracket
with 3/8- 16 x 1" Bolts and Locknuts using two 9/16" Wrenches (Figure 9).
5. Secure the rear of the Tow Bar to the Axle with 3/8-16 x 1"
Bolts and Locknuts using two 9/16" Wrenches (Figure 10).
6. Position the Yellow/Brown Wires along the left side of the axle and
up to the light location over the Fender (Figure 11).
7. Position the Green/Brown Wire along the right side of the axle and
up to the Light location over the Fender.
8. Secure the Wires under the Frame with Cable Ties at the four places
shown.
Figure 9
Wires
Figure 11
Cable Ties
Yellow/
Brown
Wire
Figure 10
Tow Bar
Rear Bracket
Road Tow
Axle
Bolt and
Locknut
Base
Tow Bar
Bolt and
Locknut
Wires
Tow Bar
Wires
Wires
Larger Hole
Hook Tool
Tow Bar
Tow Bar
Bolt and
Locknut
Road Tow
Axle
Bolt and Locknut
Wires
Cable Ties
Yellow/Brown
Wires
CONTACT US AT www.MacKissic.com 13