Safety & Operating Instructions

Figure 45
4. Secure the Tow Beam/Stand to the Hitch Supports with the 3/8-16 X 3"
Bolt and Locknut using two 9/16" Wrenches (Figure 45). Do not over
tighten because the Tow Beam/Stand must be able to rotate between
the Hitch Supports.
5. Tighten the Hardware that secures the Hitch Supports to the Base ( Figure
44).
6. Position the Tow Beam/Stand so it is vertical and install the Hand Pin
and Hitch Clip to secure it in the upright position (Figure 46). This is
the operating Position when the machine is off the tow vehicle.
7. When attaching to a tow vehicle, position the Tow Beam/Stand to
horizontal and install the Hand Pin and Hitch Clip. Secure the
Chipper to the tow vehicle Pin Hitch.
Figure 46
Avoid Death or Serious Injury. Do not tow this machine faster than 10 mph. This machine is not legal for street or highway use.
32 MacKissic Gravity Self Feeding Chipper
Hitch Plate
on Top
Tow
Beam/Stand
Bolt and
Locknut
Hand Pin
Hitch Clip
Hole for Towing
Position