Safety & Operating Instructions

Chapter 6: Chipper Accessories
The flywheel will still rotate for A WHILE after the engine is shut off. Shut down the engine, wait for all moving parts to come
to a complete stop, remove spark plug wire, then wait 5 minutes before moving or working on the chipper.
WC375 NH (NON-HIGHWAY) KIT
The Pin-Hitch Package enables your MACKISSIC GRAVITY SELF FEEDING
CHIPPER to be
towed behind your lawn tractor. Although the Chipper is very easy to move by
hand, this accessory is helpful for moving over greater distances and provides
better stability when connected to your tractor.
Tools and Supplies Needed:
 Two 9/16" wrenches
 Two 1/2" wrenches
Unpacking
Parts supplied (Figure 42):
 Two Hitch Supports
 Tow Beam/Stand
 Hitch Plate
 Hardware Package containing:
o Hand Pin
o Hitch Clip
o Two 5/16-18 x 1” Long Bolts
o Two 5/16-18 Locknuts
Note: Compare the contents of the Parts Box with the Parts Supplied list. If there
are any questions contact us at www.MacKissic.com or call 1-800-
348-1117. Do not discard the shipping materials until you are fully
satisfied with your new Pin-Hitch Package.
Installation
1. Support the Base of the Chipper to lift the Front Foot off the ground
(Figure 43).
2. Remove the four Bolts and Locknuts from the Front Foot using two
9/16" Wrenches. Remove and store the Front Support for future use.
3. Install the two Hitch Supports onto the Frame as shown with the four
Bolts and Locknuts you removed earlier using two 9/16" wrenches
(Figure 44). Leave the Hardware loose for now.
Figure 42
Front Support
Figure 43
Base
Bolt and
Bolts and
Locknuts
Hitch
Supports
Figure 44
Bolts and
Locknuts
CONTACT US AT www.MacKissic.com 31
Bolt
Hitch
Supports
Locknut
Hand Pin
Hitch Clip
Hitch Plate
Bolt and Locknut
Tow Beam/Stand
Front Support
Bolts and
Locknuts
Base
Hitch Supports
Bolts and
Locknuts