Safety & Operating Instructions

Hardware Bag Parts (Figure 3)
PART NUMBER DESCRIPTION QTY WHERE USED
1 090-0639 5/16-18 THIN NYLOCK NUTS 8 HOPPER
2 090-0748 5/16-18 X 3/4" TRUSS BOLTS 8 HOPPER
3 090-0475 5/16-18 SAE FLATWASHERS 8 HOPPER
4 090-0090 5/16-18 X 1-1/2" HHCS 1 HANDLE
5 090-0702 5/16-18 X 4-1/2" HHCS 1 HANDLE
6 090-0460 5/16-18 NYLOCK NUTS 2 HANDLE
7 090-0448 5/16-18 X 3-1/2" HHCS 2 LOW DISCHARGE
6 090-0460 5/16-18 NYLOCK NUTS 2 LOW DISCHARGE
Attaching the Hopper Assembly
Note:
We recommend that you have someone help you lift the Hopper in place and
Figure 3
Figure 4
support it until it is secured to the Chipper.
Tools Needed:
One ½” wrench and One Phillips Head Screwdriver
1. Gather x8 5/16-18 x 3/4" Truss Head Bolts, x8 5/16-18 Thin Nylon
Locknuts, and x8 5/16 SAE washers from your Bolt Bag.
2. Place the Hopper Assembly inside of the Hopper Neck.
3. From the inside of the Hopper Assembly, insert a Truss Head Bolt
through the holes (x4 each side of Hopper), place a 5/16 SAE
washer over the protruding bolt threads, and secure using a Thin
Nylon Locknut on the outside (Figure 4)
Attaching the Discharge Chute and Transport Handle
Tools Needed:
Two 1/2" Wrenches
1.
Position the Discharge Chute facing away from the Hopper Assembly
as shown and secure with two 3-1/2" long Bolts and Locknuts using
two 1/2" Wrenches (Figure 5).
Figure 4
Hopper
Assembly
Discharge
Chute
11 MacKissic Gravity Self Feeding Chipper
Discharge Chute
3-1/2” Bolts
And Locknuts
1
2
3
7
5
6
4
Figure 3
Figure 5