Safety & Operating Instructions

CONTACT US AT www.MacKissic.com
31
Chapter 6: Chipper Accessories
Disengage PTO, shut down the tractor engine, remove the key, wait for all moving parts to come to a complete stop,
disconnect the PTO shaft from the tractor, then wait 5 minutes before performing any maintenance procedure or
inspection on the chipper.
Extended Top-Discharge Chute
The Extended Top-Discharge Chute enables you to better control the
direction of the discharged chips and allows you to direct them into a
trailer or truck bed for transport.
Tools Needed:
• Two 1/2" Wrenches
INSTALLATION
1. Remove the two Bolts and Locknuts from the Low Discharge Assembly
with two 1/2" wrenches (Figure 44).
2. Remove the Low Discharge Chute from the Chipper.
3. Position the Extended Top-Discharge Chute onto the Chipper with the
Locking pin on the outside (side furthest away from the hopper)
(Figure 47).
4. Install the two Bolts and Locknuts and tighten with two 1/2" wrenches.
Low
Discharge
Chute
Bolts and
Locknuts
Figure 43
Low
Discharge
Chute
Bolts and
Locknuts