Safety & Operating Instructions

www.MacKissic.com

Attaching the PTO Shaft to the Tractor and Chipper

Insert the Key into the 3-Point Hitch Drive Shaft of the Chipper (Figure 20).

Align the Key Slot of the PTO Shaft with the Key in the Shaft and slide

it onto the Shaft.

You must install the 1/4" X 1/4" X 1-1/4" key supplied in the hardware

package where the PTO shaft attaches to the chipper. Failure to do so

will result in damage to the machine and is not covered under warranty.

NOTE: Do not allow the 3-Point Hitch Shaft to extend more than 1/4" into

the U-

Joint. This will allow proper clearance to prevent hitting the

Grease Fitting.

Secure the PTO Shaft with the two Set Screws from the Hardware

Package.

NOTE:

If you plan to leave the Chipper attached to the Tractor for extended

periods,

apply thread lock to the Set Screws to help secure them in

place.

Pull the Locking Ring while sliding the PTO shaft onto the Tractor

PTO Spline (Figure 21).

Release the Locking Ring and continue sliding the PTO Shaft on

until the Locking Ring releases and locks into the detent in the

Tractor PTO Spline.

Secure the PTO Shaft Safety Chains to stationary parts of the Chipper

Frame

and Tractor to stop the Guard from turning (Figure 22).

Figure 20

Figure 21

Figure 22

PTO

Hitch

Drive

Shaft

1/4"

PTO

Shaft

3-Point

Hitch

Drive

Shaft

PTO Shaft

Safety

Chains