Product Manual

15
STEP II – ATTACHING THE HITCH ASSEMBLY
• Place the base on Jack Stands so that the frame is level with the ground (Figure 2).
• Position the Support Leg in the down position and secure using the Pin and Hitch Clip (Figure 3).
• Attach the rear of the Tow Bar to the Rear Frame Support using a 3/8”-16 x 3” bolt and a 3/8-16 Nylon Locknut
and secure loosely.
• Attach the Tow Bar to the Front Frame Support using a 3/8”-16 x 3” bolt and 3/8-16 Nylon Locknut and tighten
using two 9/16” wrenches.
• Using two 9/16” wrenches, tighten the loose bolt from Step 3 to secure the rear of the Tow Bar.
• Remove the Jack Stands.