Instructions / Assembly

NEVER ATTEMPT TO PICK UP PLUGGED-IN FIXTURES WHEN THEY FALL INTO WATER BECAUSE FATAL
ELECTROCUTION COULD RESULT.
8. Make sure cord is located so that it will not be stepped on, tripped over, or otherwise subjected
to damage or stress.
9. Do not operate fixture if it has received a sharp blow, been dropped, or otherwise damaged in any way.
10. This fixture MUST ALWAYS BE USED in accordance with all electrical and safety codes and
ordinances, including the most recent National Electric Code (NEC) and with the Occupational
Safety and Health Administration (OSHA) Volume 1 on General Industry Standards and interpretations.
11. DO NOT replace batteries.
12. DO NOT dispose of this product in fire. Batteries inside this product may explode or leak.
13. Lithium-Ion batteries must be disposed of in accordance with local waste ordinances
and regulations.
14. DO NOT puncture this battery pack. DO NOT work on this battery pack.
15. DO NOT disassemble fixture. The fixture does not have any user serviceable parts.
16. This product is not intended to be repaired by service personal in case of failure or
component defect (unit can be thrown away).
17. This product must not be disposed of together with domestic waste. This product has to be disposed at an
authorized place for recycling of electrical and electronic appliances.
18. NEVER operate the light with the clear protective lens removed.
19. KEEP AWAY from excessive heat or flame.
20. DO NOT look directly into the light.
OPERATION
1. Depress switch in the handle one time to turn on the floodlight LED lights.
2. Depress switch a second time to turn the floodlight off and the spotlight on.
3. Depress the switch a third time to turn both the floodlight and spotlight on.
4. Depress the switch a fourth time to turn both lights off.
RECHARGING UTILITY LIGHT
1. Turn off worklight.
2. Lift up USB cover on the lower side of the worklight handle.
3. Insert the battery charger plug into the jack on the worklight handle.
4. Plug the supplied cable into the worklight and any USB 2.0 or 3.0 Port. Maximum ratings: 5 Vdc, 1.0A.
NOTE: Batteries will reach full charge in 5 to 6 hours. LED indicator light glows red while the batteries are
charging. When the light is fully charged, the LED indicator turns to green, and the unit will maintain full charge
while plugged in.
HANGING UTILITY LIGHT
1. Retractable hanging hook can rotate 360°.
2. Magnets included for attachment to metal surfaces. Clings to most metal surfaces.
WARNING: Do not use magnet for horizontal overhead mounting.
CAUTION: Do not slide on finished painted surfaces as magnet may scratch finish.
USING BELT CLIP
1. Slide belt clip over various surfaces for temporary hanging worklight.
Questions?1-800-334-6871 [e-mail]