Instruction manual

UNI FLAME AUTOLIFT
INSTALLATION & OPERATION
Installation of self shielded arc welding (No Gas)
(1) Turn the power source on and select the MIG function through the STICK/MIG
selector. (See Panel Structure Diagram Number 7)
(2) Plug the welding torch into the output socket “10” on the front panel, (See Panel
Structure Diagram Number 10) and tighten it.
(3) Insert the earth cable plug into the positive socket “9” on the Panel Structure
Diagram, and tighten it clockwise.
(4) Insert the fast plug on the wire feeder into the output socket “NO GAS” on the
clapboard, and tighten it clockwise. (See Clapboard Structure Diagram Number 16)
(5) Remove the right side cover of the unit and push the wire spool onto the spindle.
Make free the end of the wire and cut it smoothly. Unlock the pressure arm and align
the wire into the groove of the drive roll putting a short part of the wire into the torch
receptacle. Check that the drive roll and contact tip being used complies with the wire
diameter, replace if necessary. Lock the pressure arm and check that the bearing roll
presses the wire exactly into the groove.
(5a) Please note that a knurled drive roller sholud be fitted when using self shielded
wire.
(6) Press selector switch on for “wire inching” (See Panel Structure Diagram Number 3)
Press and hold until wire is visible at end of torch.
(7) Adjust the welding voltage adjustment knob and wire feeding speed adjustment
knob according to practical needs to get the desired welding voltage and welding
current. (See Panel Structure Diagram Number 5&6)
(8) Press the welding torch switch, and welding can be carried out.
(9) Adjust the burnback time potentiometer on the clapboard to get the desired length of
welding wire stretching into the contact tip after welding.
(See Clapboard Structure Diagram Number 14)
Installation sketch map
WARNING!
Disconnect the Electrode Holder cable
from the machine before using MIG
function. If cable is not disconnected
welding voltage is present and can cause
arcing or flash.