Instruction manual

17
(2) Set Standard/Spoolgun
selector switch to Standard
(3) Connect Mig torch
(1) Set Tig/MMA/Mig selector
switch to Mig
IMPORTANT : When connecting the torch
besuretotightentheconnection.
(4) Connect earth lead to
Installation set up for MIG with Gasless wire for UNI-MIG MIG250 MTS
(1) Switch on the machine, select the MIG function with the Tig/MMA/Mig selector switch.
(2) Select Standard using the Standard/Spool Gun selector switch.
(3) Plug the welding torch into the Euro Mig torch connection socket on the front panel, and tighten it.
IMPORTANT : When connecting the torch be sure to tighten the connection. A loose connection can
result in the connector arcing and damaging the machine and gun connector.
This damage is not covered under warranty.
(4) Insert the earth cable plug into the Positive socket on the front of the machine and tighten it.
(5) Connect the weld power cable plug inside the wire feeder to the output socket NO GAS, and tighten it.
(6) Fit the correct size Knurled drive roller for Gas Less Flux Core wire.
(7) Place the Wire Spool onto the Spool Holder - Note: the spool retaining nut is Left Hand thread.
Snip the wire from the spool being sure to hold the wire to prevent rapid uncoiling. Feed the wire into
the wire feeder inlet guide tube through to the drive roller.
Caution:
Disconnect the Electrode Holder cable from the machine before using MIG function. If cable is not disconnected welding
voltage is present and can cause arcing or ash.
(5) Connect weld power lead to
NO GAS
(7) Place wire onto spool holder - (spool
retaining nut is left hand thread ) Feed the wire
through the inlet guide tube on to the drive
roller.
(6) Fit the correct sized Knurled
Drive roller for Gas Less Flux
Cored wire
Note: Pictures may vary from your model machine