Operating instructions/Installation instructions
Table Of Contents
- Contents
- Help protect our environment
- IMPORTANT SAFETY INSTRUCTIONS
- Operating the washing machine
- Environmentally friendly washing
- Before using for the first time
- Removing the protective film and stickers
- Remove the detergent cartridges and the drain hose elbow from the drum
- Miele@home
- Switching on the washing machine
- 1. Setting the display text
- 2. Setting up Miele@home
- 3. Setting the clock format
- 4. Removing the shipping struts
- 5. Commissioning TwinDos
- 6. Starting the calibration program
- 1. Prepare the laundry
- 2. Selecting a program
- 3. Selecting program settings
- 4. Loading the washing machine
- 5. Adding detergent
- 6. Starting a program
- 7. Program end
- Spin cycle
- Program guide
- Extra options
- Wash program overview – extra options
- Program sequence
- Changing the program sequence
- Favorite programs
- Washing assistant
- Timer
- Detergent
- Cleaning and care
- Frequently Asked Questions
- A wash program cannot be started
- Fault message after a program has been interrupted
- Fault message after the end of the program
- Fault message after the end of the program
- Messages or faults affecting the TwinDos system
- Messages or faults affecting the TwinDos system
- General problems with the washer
- General problems with the washing machine
- Poor wash results
- The drum door cannot be opened
- Opening the door in the event of a blocked drain outlet and/or power outage
- Customer Service
- Installation
- Front view
- Rear view
- Installation surface
- Transporting the washing machine to its installation site
- Removing the shipping struts
- Installing the shipping struts
- Leveling the machine
- Additional installation requirements
- Product Dimensions
- The water protection system
- Water intake
- Water drainage
- Electrical connection
- Technical data
- Settings
- Detergents and care products
Frequently Asked Questions
The drum door cannot be opened
Problem Possible cause and solution
The door cannot be
pulled open during a
program.
The drum is locked during a program.
Touch the Start/Stop sensor button to cancel the
program.
The program is canceled, the door will unlock, and
you will be able to pull it open.
There is still water in the drum and the machine is
unable to drain.
Clean the drain filter and the drain pump as
described in “Opening the door in the event of a
blocked drain outlet and/or power outage”.
Comfort Cooling
appears in the display
after a program has
been canceled.
To protect the user against scalding, the door cannot
be opened if the suds temperature is higher than
130°F (55°C).
Wait until the temperature in the drum has
decreased and the message has gone out in the
display.
The following appears
in the display:
The door lock is jammed.
Contact Service.
The door lock has jammed.
Contact Customer Service.
78