Operating instructions/Installation instructions
Table Of Contents
- Contents
- Help protect our environment
- IMPORTANT SAFETY INSTRUCTIONS
- Operating the washing machine
- Environmentally friendly washing
- Before using for the first time
- Removing the protective film and stickers
- Remove the detergent cartridges and the drain hose elbow from the drum
- Miele@home
- Switching on the washing machine
- 1. Setting the display text
- 2. Setting up Miele@home
- 3. Setting the clock format
- 4. Removing the shipping struts
- 5. Commissioning TwinDos
- 6. Starting the calibration program
- 1. Prepare the laundry
- 2. Selecting a program
- 3. Selecting program settings
- 4. Loading the washing machine
- 5. Adding detergent
- 6. Starting a program
- 7. Program end
- Spin cycle
- Program guide
- Extra options
- Wash program overview – extra options
- Program sequence
- Changing the program sequence
- Favorite programs
- Washing assistant
- Timer
- Detergent
- Cleaning and care
- Frequently Asked Questions
- A wash program cannot be started
- Fault message after a program has been interrupted
- Fault message after the end of the program
- Fault message after the end of the program
- Messages or faults affecting the TwinDos system
- Messages or faults affecting the TwinDos system
- General problems with the washer
- General problems with the washing machine
- Poor wash results
- The drum door cannot be opened
- Opening the door in the event of a blocked drain outlet and/or power outage
- Customer Service
- Installation
- Front view
- Rear view
- Installation surface
- Transporting the washing machine to its installation site
- Removing the shipping struts
- Installing the shipping struts
- Leveling the machine
- Additional installation requirements
- Product Dimensions
- The water protection system
- Water intake
- Water drainage
- Electrical connection
- Technical data
- Settings
- Detergents and care products
Frequently Asked Questions
General problems with the washing machine
Problem Possible cause and solution
The fabric softener is
not completely dis-
pensed or too much
water remains in the
compartment.
The siphon tube is either positioned incorrectly or
clogged.
Clean the siphon tube, see “Cleaning and care -
Cleaning the detergent drawer”.
At the end of the pro-
gram there is still liquid
in the capsule.
The small pipe in the detergent dispenser drawer
onto which the capsule is placed is blocked.
Clean the small pipe.
Not a fault.
For technical reasons, a small amount of water will
remain in the capsule.
There is water next to
the capsule in the fabric
softener compartment.
CapDosing was not activated or an empty capsule
was not removed at the end of the last wash
program.
Make sure that you remember to activate
CapDosing the next time you insert a capsule.
Remove and then dispose of the empty capsule at
the end of each wash cycle.
The small pipe in the detergent dispenser drawer
onto which the capsule is placed is blocked.
Clean the small pipe.
76