Operating instructions/Installation instructions
Table Of Contents
- Contents
- Help protect our environment
- IMPORTANT SAFETY INSTRUCTIONS
- Operating the washing machine
- Environmentally friendly washing
- Before using for the first time
- Removing the protective film and stickers
- Remove the detergent cartridges and the drain hose elbow from the drum
- Miele@home
- Switching on the washing machine
- 1. Setting the display text
- 2. Setting up Miele@home
- 3. Setting the clock format
- 4. Removing the shipping struts
- 5. Commissioning TwinDos
- 6. Starting the calibration program
- 1. Prepare the laundry
- 2. Selecting a program
- 3. Selecting program settings
- 4. Loading the washing machine
- 5. Adding detergent
- 6. Starting a program
- 7. Program end
- Spin cycle
- Program guide
- Extra options
- Wash program overview – extra options
- Program sequence
- Changing the program sequence
- Favorite programs
- Washing assistant
- Timer
- Detergent
- Cleaning and care
- Frequently Asked Questions
- A wash program cannot be started
- Fault message after a program has been interrupted
- Fault message after the end of the program
- Fault message after the end of the program
- Messages or faults affecting the TwinDos system
- Messages or faults affecting the TwinDos system
- General problems with the washer
- General problems with the washing machine
- Poor wash results
- The drum door cannot be opened
- Opening the door in the event of a blocked drain outlet and/or power outage
- Customer Service
- Installation
- Front view
- Rear view
- Installation surface
- Transporting the washing machine to its installation site
- Removing the shipping struts
- Installing the shipping struts
- Leveling the machine
- Additional installation requirements
- Product Dimensions
- The water protection system
- Water intake
- Water drainage
- Electrical connection
- Technical data
- Settings
- Detergents and care products
5. Adding detergent
35
Adding fabric softener
Add the fabric softener or the liquid
starch to the compartment. Do not
exceed the maximum level mark.
It will be automatically dispensed in the
final rinse cycle. At the end of the
program, a small amount of water
remains in the compartment.
If starching frequently, clean the
dispenser compartment, especially
the siphon, regularly.
Tips for dispensing
Adjust the detergent dosage to the level
of soiling of the laundry and the
maximum load. Reduce the amount of
detergent with smaller loads (e.g.,
reduce the amount of detergent by ⅓
when washing a half load).
Too little detergent:
- The laundry is not cleaned properly
and may become gray and hard to
the touch over time.
- Can lead to a build-up of bacteria in
the washing machine.
- Grease is not completely removed
from the laundry.
- Can lead to limescale deposits on the
heater elements.
Too much detergent
- Poor wash, rinse, and spin results.
- Causes higher water consumption as
an extra rinse cycle is automatically
activated.
- A greater burden on the environment.
Using detergent tablets or pods
Always put detergent tablets or pods
directly in the drum with the laundry.
They cannot be added via the detergent
dispenser drawer.
See “Detergent” for more information
about detergents and how much to
dispense.