Operating instructions/Installation instructions
Table Of Contents
- Contents
- Help protect our environment
- IMPORTANT SAFETY INSTRUCTIONS
- Operating the washing machine
- Environmentally friendly washing
- Before using for the first time
- Removing the protective film and stickers
- Remove the detergent cartridges and the drain hose elbow from the drum
- Miele@home
- Switching on the washing machine
- 1. Setting the display text
- 2. Setting up Miele@home
- 3. Setting the clock format
- 4. Removing the shipping struts
- 5. Commissioning TwinDos
- 6. Starting the calibration program
- 1. Prepare the laundry
- 2. Selecting a program
- 3. Selecting program settings
- 4. Loading the washing machine
- 5. Adding detergent
- 6. Starting a program
- 7. Program end
- Spin cycle
- Program guide
- Extra options
- Wash program overview – extra options
- Program sequence
- Changing the program sequence
- Favorite programs
- Washing assistant
- Timer
- Detergent
- Cleaning and care
- Frequently Asked Questions
- A wash program cannot be started
- Fault message after a program has been interrupted
- Fault message after the end of the program
- Fault message after the end of the program
- Messages or faults affecting the TwinDos system
- Messages or faults affecting the TwinDos system
- General problems with the washer
- General problems with the washing machine
- Poor wash results
- The drum door cannot be opened
- Opening the door in the event of a blocked drain outlet and/or power outage
- Customer Service
- Installation
- Front view
- Rear view
- Installation surface
- Transporting the washing machine to its installation site
- Removing the shipping struts
- Installing the shipping struts
- Leveling the machine
- Additional installation requirements
- Product Dimensions
- The water protection system
- Water intake
- Water drainage
- Electrical connection
- Technical data
- Settings
- Detergents and care products
Before using for the first time
24
Settings for compartment
The dispensing quantity for
UltraPhase2 for (hardness level I)
is pre-set.
36
35
34
37
38
Dosage for comp.
ml
11:02
OK
Confirm the pre-set value with the
OKsensor button, or change the
value.
UltraPhase2
Hardness level I 36ml
Hardness level II 45ml
Hardness level III 54ml
The following will appear in the display:
Insert container
Remove the cover from the detergent
cartridge.
Push the UltraPhase2 detergent
cartridge into compartment2 until it
locks into position.
When the cartridge is pushed in, the
display message switches to:
“TwinDos” is set up. Corrections can be
made in “Settings” / “TwinDos”.
Confirm with the OK sensor button.
Close the TwinDos flap.
The display for the calibration program.