Operating instructions/Installation instructions

Before using for the first time
22
5. Commissioning TwinDos
Skip Continue
Set up “TwinDos”?

 Touch the Continuesensor button to
set TwinDos up right away.
Tip: To postpone setup until later: touch
the Skipsensor button. The following
message will then appear in the display:
It is possible to set up later in in
“Settings” / “TwinDos”.
Confirm with the OKsensor button.
Determining the water hardness
Water hardness is an indication of the
amount of minerals dissolved in water.
The more minerals in the water, the
higher the water hardness and more
detergent must be dispensed.
Tip: You can measure the water
hardness yourself using the enclosed
test strip. Alternatively, your local water
authority will be able to tell you the
hardness of water in your area.
 Dip the test strip in the water for
approx. 1second. Shake excess
water off the test strip.
After approx. 1minute, and based on
the coloration, you will be able to read
the water hardness from the table
below.
Test strip Hardness range
4green areas Hardness level I
1red area
2red areas Hardness level II
3red areas Hardness level III
4red areas
Settings for compartment
The procedure for Miele UltraPhase 1
and Miele UltraPhase 2 is described
below.
No agent
Agent for comp. 
Miele
UltraPhase 1
OK
11:02
 Touch the Miele UltraPhase 1sensor
button.
The following message will then appear
in the display:
Please enter the dosage recommendation
of your detergent for a wash with normal
soiling. Note your water hardness level.
The dispensing quantity for
UltraPhase1 for (hardness level I)
is pre-set.