Operating instructions/Installation instructions
Table Of Contents
- Contents
- Help protect our environment
- IMPORTANT SAFETY INSTRUCTIONS
- Operating the washing machine
- Environmentally friendly washing
- Before using for the first time
- Removing the protective film and stickers
- Remove the detergent cartridges and the drain hose elbow from the drum
- Miele@home
- Switching on the washing machine
- 1. Setting the display text
- 2. Setting up Miele@home
- 3. Setting the clock format
- 4. Removing the shipping struts
- 5. Commissioning TwinDos
- 6. Starting the calibration program
- 1. Prepare the laundry
- 2. Selecting a program
- 3. Selecting program settings
- 4. Loading the washing machine
- 5. Adding detergent
- 6. Starting a program
- 7. Program end
- Spin cycle
- Program guide
- Extra options
- Wash program overview – extra options
- Program sequence
- Changing the program sequence
- Favorite programs
- Washing assistant
- Timer
- Detergent
- Cleaning and care
- Frequently Asked Questions
- A wash program cannot be started
- Fault message after a program has been interrupted
- Fault message after the end of the program
- Fault message after the end of the program
- Messages or faults affecting the TwinDos system
- Messages or faults affecting the TwinDos system
- General problems with the washer
- General problems with the washing machine
- Poor wash results
- The drum door cannot be opened
- Opening the door in the event of a blocked drain outlet and/or power outage
- Customer Service
- Installation
- Front view
- Rear view
- Installation surface
- Transporting the washing machine to its installation site
- Removing the shipping struts
- Installing the shipping struts
- Leveling the machine
- Additional installation requirements
- Product Dimensions
- The water protection system
- Water intake
- Water drainage
- Electrical connection
- Technical data
- Settings
- Detergents and care products
Operating the washing machine
Control panel
Start/Stop
a
sensor button
Takes you back one level in a menu.
b
Touch display
c
Start/Stopsensor button
Touching the Start/Stopsensor button starts the selected program or cancels a
program that has already been started. The program can be started as soon as
the sensor button is flashing on and off. The sensor button lights up constantly
once the program has started.
d
Optical interface
This is used by the Service department as a transmission point.
e
button
For switching the washing machine on and off. To save energy, the washing
machine will switch off automatically. This occurs 15minutes after the end of
the program/anti-crease phase, or after being switched on if no further
selection is made.
Touch display and sensor buttons
The and Start/Stopsensor buttons and the sensor buttons in the display react
to finger tip contact.
The touch display can be scratched by pointed or sharp objects, e.g., pens.
Only touch the display with your fingers.
12