Operating instructions/Installation instructions

Settings
108
Installation requirements
Low water pressure
If the water pressure is below 14.5psi
(1bar), the program will be canceled
and the fault message Water intake
fault. Open the water supply. will appear.
If the on-site water pressure cannot be
increased, activating this function will
prevent the program from being
canceled.
Low water pressure is deactivated as
standard.
Suds cooling
Additional water flows into the drum at
the end of the main wash to cool the
suds down.
Suds cooling takes place when a
Cottons program with a temperature of
158°F (70°C) or higher is selected.
Suds cooling should be activated:
- To prevent the danger of scalding if
the drain hose is hooked over the
edge of a sink or basin.
- Where the drainage pipes do not
comply with DIN1986.
Suds cooling is deactivated as
standard.
Temperature reduction
At high altitudes, water has a lower
boiling point. Miele recommends
activating the reduced-temperature
setting at altitudes of 6,560 ft
(2,000m) or above to prevent water
from boiling. The maximum
temperature is reduced to 176°F
(80°C), even if a higher temperature
has been selected.
The reduced-temperature setting is
deactivated as standard.