Operating instructions/Installation instructions
Table Of Contents
- Contents
- Help protect our environment
- IMPORTANT SAFETY INSTRUCTIONS
- Operating the washing machine
- Environmentally friendly washing
- Before using for the first time
- Removing the protective film and stickers
- Remove the detergent cartridges and the drain hose elbow from the drum
- Miele@home
- Switching on the washing machine
- 1. Setting the display text
- 2. Setting up Miele@home
- 3. Setting the clock format
- 4. Removing the shipping struts
- 5. Commissioning TwinDos
- 6. Starting the calibration program
- 1. Prepare the laundry
- 2. Selecting a program
- 3. Selecting program settings
- 4. Loading the washing machine
- 5. Adding detergent
- 6. Starting a program
- 7. Program end
- Spin cycle
- Program guide
- Extra options
- Wash program overview – extra options
- Program sequence
- Changing the program sequence
- Favorite programs
- Washing assistant
- Timer
- Detergent
- Cleaning and care
- Frequently Asked Questions
- A wash program cannot be started
- Fault message after a program has been interrupted
- Fault message after the end of the program
- Fault message after the end of the program
- Messages or faults affecting the TwinDos system
- Messages or faults affecting the TwinDos system
- General problems with the washer
- General problems with the washing machine
- Poor wash results
- The drum door cannot be opened
- Opening the door in the event of a blocked drain outlet and/or power outage
- Customer Service
- Installation
- Front view
- Rear view
- Installation surface
- Transporting the washing machine to its installation site
- Removing the shipping struts
- Installing the shipping struts
- Leveling the machine
- Additional installation requirements
- Product Dimensions
- The water protection system
- Water intake
- Water drainage
- Electrical connection
- Technical data
- Settings
- Detergents and care products
Settings
100
Volume
Finish tone
The volume of the audible signal that
sounds at the end of the program can
be changed.
It can be set to one of 7 different levels
or switched off altogether.
Keypad tone
The volume of the audible signal that
sounds when a sensor button is
touched can be changed.
It can be set to one of 7 different levels
or switched off altogether.
Display Brightness
The brightness of the display can be
altered.
It can be set to one of 7different levels.
Units
The temperature and spin speed
values can be displayed in different
ways.
Options
- Clear text (factory default)
The values are displayed as words.
- °C + rpm
The temperatures are displayed as
figures in °C.
- °F + rpm
The temperatures are displayed as
figures in °F.
“Display” off status
The display and the sensor button
lighting is switched off to save energy.
The Start/Stopsensor button flashes
slowly.
Options
- Off
The lighting remains switched on.
- On (factory default)
The lighting switches off after
10minutes.
- On -Not in current prog.
The lighting remains switched on
throughout the program. The lighting
switches off 10minutes after the
program has ended.